Beretta .410ga Mobil Flush Fit

Placeholder

Beretta .410ga Mobil Flush Fit

£23.00

The flush fitting Mobil choke from Beretta is used in most older 686 & 687 Silver Pigeons as well as the current Silver Pigeon field models plus the 687EELL Diamond Pigeon range, it is noticeably shorter than the current Optima and Optima H.P range with a thread at the muzzle end of the choke.

Clear

Description

Mobilchoke System

Introduced in the mid 1980’s the Mobilchoke tube system was first available for the model S687L over and under and later carried through virtually every model of fixed breech and semi-automatic shotgun. At this time the Mobilechoke is the only choke tube system adapted by Beretta to 12, 20, 28 gauge and .410.  The Mobilchoke system continues to be the mainstay of the 680 series field grade over and under shotguns.

The conical parallel design of the Beretta choke tubes creates a more gradual taper inside the choke tube which gently transitions into a parallel section that runs to the muzzle end of the tube. The conical parallel design results in reduced shot deformation, improved pattern uniformity and increased pattern density.

Identifying Characteristics:

The following pertains specifically to 410 gauge Mobilchoke tubes. While the dimensions noted will vary for the 12, 20 gauge and 28 tubes, identification is very much self evident.

Barrels that use the Mobilchoke will typically be marked only with the gauge marking.

Mobilchoke choke tubes will be marked PB or ST and the degree of choke. If the choke tube is steel shot compatible it will also be marked SP .

Additional information

Beretta Mobil Flush

Skeet (SK), Cylinder (C****), 1/4 (****), 1/2 (***), 3/4 (**), Full (*)

Reviews

There are no reviews yet.

Be the first to review “Beretta .410ga Mobil Flush Fit”

Your email address will not be published.